Canada - A/T - Fluid Leak From Missing Case Plug
Bulletin
TSB3524
Issue Date
January 10, 2011
Market
Canada
Title
AUTOMATIC TRANSAXLE FLUID LEAK FROM MISSING TRANSAXLE CASE PLUG (U760)
Component
AUTOMATIC TRANSMISSION
Models
'10 Camry; '09 Venza
INTRODUCTION:
Some 2009 model year Venza and 2010 model year Camry vehicles may display a transaxle fluid leak from a missing transaxle case plug on the upper right hand side of the transaxle case. Production improvements have been implemented to prevent this from occurring. Follow the repair procedure below to install the missing transaxle case plug.
APPLICABILITY:
PRODUCTION CHANGE INFORMATION:
This TSB applies to vehicles produced BEFORE the Production Change Effective VIN shown.
WARRANTY INFORMATION:
PARTS INFORMATION:
REQUIRED TOOLS & EQUIPMENT:
NOTE:
- Additional Techstream units may be ordered by completing the order form on ETAS and faxing it to (416) 431-8342.
- Additional SSTs may be ordered by calling SPX/OTC at 1-800-933-8335.
REPAIR PROCEDURE:
1. Inspect the transaxle to determine if the transaxle case plug is installed.
Is the plug missing?
- YES - Proceed to step 2.
- NO - This TSB does NOT apply. Proceed with diagnosis of the ATF leak.
2. Install the missing transaxle case plug.
3. Adjust the ATF level.
Refer to the Repair Manual within E-TAS / TIS library:
- Division: Toyota
- Model: Camry
- Year: 2010
- Service Category: Drivetrain
- Section: Automatic Transmission/Transaxle
- Keyword: U760E Automatic Transaxle: Automatic Transaxle Fluid: Adjustment
- Division: Toyota
- Model: Venza
- Year: 2009
- Service Category: Drivetrain
- Section: Automatic Transmission/Transaxle
- Keyword: U760E / U760F Automatic Transaxle: Automatic Transaxle Fluid: Adjustment
4. Test drive the vehicle to confirm the repair.
NOTE::
Issue of this Technical Service Bulletin is to ensure that proper repair information is available. IT DOES NOT CONSTITUTE AN AUTHORIZATION FOR REPAIR. Normal provisions of the formal warranty policy, as applicable, will apply.