Canada - Instruments - Compass Calibration Procedure

Bulletin
TSB3321

Issue Date
November 20, 2009

Market
Canada

Title
INITIAL CALIBRATION OF COMPASS DURING PDS

Component
GENERAL INFORMATION

Models
'10 Venza

INTRODUCTION:
Some 2010 model year Venza vehicles are equipped with a compass in the rear view mirror. Use the following procedure to complete initial calibration of the compass during Pre-Delivery Service (PDS).











APPLICABILITY:






WARRANTY INFORMATION:


COMPASS CALIBRATION PROCEDURE:







1. Cycle the ignition switch to the "IG-ON" position and push and hold the "AUTO" switch for 6 seconds until the zone number appears on the compass display.

HINT:
Pushing the "AUTO" switch for 3 seconds turns the compass display ON or OFF.

2. Push the "AUTO" switch to select the number of the zone where the vehicle is located.







See the map in figure 3 for zone reference.







3. Start the engine and push and hold the "AUTO" switch for 9 seconds until "C" appears on the display.







4. Drive the vehicle slowly at (8 km/h) 5 mph or less in a circle until the direction is displayed. If there is NOT enough space to drive in a circle, drive around the block until the direction is displayed.

Once the direction is displayed, the calibration is complete.

NOTE:
- Do NOT perform calibration of the compass in a place where the Earth's magnetic field is subject to interference by artificial magnetic fields (underground parking, under a steel tower, between buildings, roof parking, near a railroad crossing, near a large vehicle, etc.)
- During calibration, do NOT operate electric systems (moon roof, power windows, etc.) as they may interfere with the calibration.