Slip Indicator Light Does Not Come ON

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: Slip Indicator Light does not Come ON
- Slip Indicator Light does not Come ON

DESCRIPTION

The skid control ECU is connected to the combination meter via CAN communication.

WIRING DIAGRAM

Refer to Slip Indicator Light Remains ON Slip Indicator Light Remains ON.

INSPECTION PROCEDURE

PROCEDURE

1. CHECK CAN COMMUNICATION SYSTEM

(a) Check if a CAN communication system DTC is output Diagnosis System.

Result:





B -- INSPECT CAN COMMUNICATION SYSTEM How to Proceed With Troubleshooting
A -- Continue to next step.

2. READ VALUE USING TECHSTREAM (SLIP INDICATOR LIGHT)

(a) Connect the Techstream to the DLC3.

(b) Start the engine.

(c) Select the Active Test on the Techstream Data List / Active Test.

ABS/VSC/TRAC

ABS/VSC/TRAC:

(d) Check that the slip indicator light on the accessory meter turns on or off in accordance with the Techstream operation.

OK:

The slip indicator light turns on or off in accordance with the Techstream operation.

HINT
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part Problem Symptoms Table.

NG -- INSPECT COMBINATION METER ASSEMBLY

OK -- REPLACE BRAKE ACTUATOR ASSEMBLY Removal

3. INSPECT COMBINATION METER ASSEMBLY

(a) Turn the ignition switch off.

(b) Turn the ignition switch to ON and check the slip indicator light will come on for approximately 3 seconds (initial check).

(c) Perform the Active Test of the combination meter (meter CPU) using the Techstream Meter / Gauge System.

(d) Check the accessory meter.

Result:





HINT
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step Problem Symptoms Table.

C -- REPLACE ACCESSORY METER ASSEMBLY Removal

B -- REPLACE COMBINATION METER ASSEMBLY Removal

A -- REPLACE BRAKE ACTUATOR ASSEMBLY Removal