VI. Supplement

A. PARTS

B. TOOLS, EQUIPMENT & MATERIALS

^ Standard hand tools

^ Nylon pry tools

^ Protective eyewear








C. COMPONENTS

D. DRIVER'S SUN VISOR REPLACEMENT (BASED UPON INSPECTION)





1. POSITION THE DRIVER'S SUN VISOR

a) Position the sun visor at a right angle to the bracket cover as shown.

b) Make sure the sun visor is attached to the holder hook.

NOTE:

DO NOT work with the sun visor tilted, doing so may damage or warp the installation hole on the roofs inner panel.





2. REMOVE THE DRIVER'S SUN VISOR

a) Insert a nylon pry tool into the visor bracket cover slot and twist to separate it from the base.





b) Once the visor bracket cover has separated from the base pull it down evenly.

NOTE:

The bracket cover does not need to be removed from the sun visor.





c) While supporting the sun visor with both hands detach it from the holder hook and pull directly down to remove.

NOTE:

Apply force only to the sun visor when removing to prevent the damage or warping of the installation hole on the roofs inner panel.





d) Remove the clips from the roof panel if still attached.

NOTE:

^ DO NOT drop the clips inside the roof panel during removal.

^ Take care to prevent the clips from coming off during removal.





3. TEMPORARILY INSTALL THE DRIVER'S SUN VISOR BRACKET COVER

a) Position the NEW sun visor and bracket base at a right angle to each other as shown.





b) Verify the 2 clips are properly attached to the NEW sun visor bracket base.





c) Using the markings align the NEW bracket cover to the NEW sun visor bracket base.





d) Insert the NEW bracket cover to the NEW sun visor bracket base as shown.





e) Temporarily set the NEW inner bracket cover claws to the NEW sun visor bracket base as shown.

NOTE:

Setting the inner claws will keep the bracket cover in place, allowing the installation of the sun visor.

NOTE:

DO NOT set the outer claws of the bracket cover. Doing so will prevent the installation of the sun visor.





4. INSTALL THE NEW DRIVER'S SUN VISOR

a) Support the NEW sun visor with both hands as shown.

b) Align the NEW sun visor with the installation hole then push straight up to install.

c) Attach the NEW sun visor to the holder hook.

NOTE:

^ Forcefully pushing the sun visor without aligning it with the installation hole may damage or warp the roof's inner panel.

^ If the bracket base does not set, remove the sun visor and restart the installation process.

^ DO NOT hold the sun visor near the bracket cover during the installation process.





d) Verify the NEW sun visor bracket base is firmly attached (no gap) to the headliner.

NOTE

If the sun visor bracket base is not firmly attached the clip(s) may not be set.





e) Push up evenly on the NEW bracket cover to set the 4 outer claws.

E. RECALLED PARTS DISPOSAL

As required by Federal Regulations please make sure all recalled parts (original parts) removed from the vehicle are rendered unusable so they will not be reused. Please keep all replaced parts for possible Warranty Parts Recovery and inspection.