Removal

AXLE: REAR AXLE HUB AND BEARING:

REMOVAL

HINT: COMPONENTS: (Components)

- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.

1. REMOVE REAR WHEEL
2. DISCONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH





(a) Remove the bolt and separate the flexible hose from the shock absorber.





(b) Remove the 2 bolts and separate the rear disc brake caliper assembly.

NOTE: Use a string or similar device to keep the brake caliper from hanging down by the flexible hose.

3. REMOVE REAR DISC
4. DISCONNECT SKID CONTROL SENSOR
(a) Disconnect the connector.
5. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH





(a) Remove the 4 bolts and hub & bearing assembly LH.