Installation

A246E AUTOMATIC TRANSAXLE: VALVE BODY ASSEMBLY:

COMPONENTS













INSTALLATION

1. INSTALL TRANSMISSION VALVE BODY ASSEMBLY





(a) Coat 3 new O-rings with ATF and install them to each solenoid valves.
(b) Install the No. 1 and No. 2 solenoid valves with the bolt (A bolt).
(c) Install the No. 3 solenoid valve with the bolt (B bolt).
(d) Install the line pressure control solenoid valve and lock plate with the bolt (C bolt).
Bolt A - Torque: 11 Nm (110 kgf-cm, 8 ft-lbf)
Bolt B - Torque: 11 Nm (110 kgf-cm, 8 ft-lbf)
Bolt C - Torque: 6.5 Nm (66 kgf-cm, 58 in-lbf)

Bolt length:
Bolt A - 25 mm (0.984 in.)
Bolt B - 60 mm (2.362 in.)
Bolt C - 12 mm (0.472 in.)





(e) Using needle-nose pliers, while connecting the manual valve connecting rod to the manual valve lever, install the valve body with the manual valve together.





(f) Install the 17 bolts.
Bolt length:
Bolt A
20 mm (0.79 in.)
Bolt B
28 mm (1.10 in.)
Bolt C
50 mm (1.97 in.)
Torque: 10 Nm (100 kgf-cm, 7 ft-lbf)





(g) Install the manual detent spring with the bolt.
Torque: 10 Nm (100 kgf-cm, 7 ft-lbf)





(h) Connect the 4 solenoid connectors.
2. INSTALL VALVE BODY OIL STRAINER ASSEMBLY





(a) Install the oil strainer with the 3 bolts.
Bolt length:
Bolt A
12 mm (0.47 in.)
Bolt B
20 mm (0.79 in.)
Torque: 10 Nm (100 kgf-cm, 7 ft-lbf)
3. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY





(a) Install the 2 magnets to the oil pan.





(b) Install a new gasket to the oil pan and install them to the transaxle.
(c) Install the 18 bolts.
Torque: 5.3 Nm (55 kgf-cm, 48 in-lbf)
4. INSTALL ENGINE UNDER COVER LH
5. ADD AUTOMATIC TRANSAXLE FLUID
ATF type:
T-IV
Capacity:
3.0 liters (3.2 US qts, 2.6 lmp. qts)
6. INSPECT AUTOMATIC TRANSAXLE FLUID

HINT: (Procedures)

7. RESET MEMORY

HINT: (Programming and Relearning)