Installation

A246E AUTOMATIC TRANSAXLE: TRANSMISSION CONTROL CABLE ASSEMBLY:

COMPONENTS

INSTALLATION

1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Install the retainer to the shift cable.
(b) Pull in the control cable assembly to the body.

(d) Install the control cable to the shift lever plate.

(e) Connect the control cable end to the floor shift assembly.

HINT: Install it with the uneven surface facing up.

(f) Install the control cable with the 2 nuts to the body.
Torque: 5.0 Nm (50 kgf-cm, 44 in-lbf)

(g) Connect the control cable to the control cable support.
(h) Temporarily install the control cable to the control shaft lever with nut.

(i) Install the control cable with the clip to the bracket.

NOTE: Insert the cable securely.

2. INSTALL AIR CLEANER ASSEMBLY WITH HOSE
Torque: 7.0 Nm (71 kgf-cm, 62 in-lbf)
3. INSTALL FRONT FLOOR HEAT INSULATOR NO.1
(a) Install the heat insulator with the 3 nuts.
Torque: 5.0 Nm (50 kgf-cm, 44 in-lbf)
4. INSTALL EXHAUST PIPE ASSEMBLY FRONT

HINT: (Installation)

5. INSTALL FLOOR PANEL BRACE FRONT
(a) Install the floor panel brace with the 2 nuts.
Torque: 30 Nm (302 kgf-cm, 22 ft-lbf)
6. INSTALL OXYGEN SENSOR CONNECTOR
(a) Connect the oxygen sensor connector.
(b) Install the floor carpet and foot rest.
7. INSTALL AIRBAG SENSOR ASSEMBLY CENTER
SST: 09249-63010
8. ADJUST SHIFT LEVER POSITION (Adjustments)

9. INSPECT SHIFT LEVER POSITION (Adjustments)

10. INSPECT SRS WARNING LIGHT

HINT: (Check Mode Procedure)