Installation

AXLE: REAR AXLE HUB:

COMPONENTS






INSTALLATION

1. INSTALL REAR AXLE HUB & BEARING ASSEMBLY LH





(a) Install the hub & bearing assembly LH with the 4 bolts.
Torque: 61 Nm (622 kgf-cm, 45 ft-lbf)
2. CONNECT SKID CONTROL SENSOR WIRE (WITH ABS)

NOTE: Do not twist the sensor wire when connecting it.

3. INSTALL REAR DISC (DISC REAR BRAKE TYPE)
4. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH (DISC REAR BRAKE TYPE)





(a) Install the rear disc brake caliper assembly LH with 2 bolts.
Torque: 47 Nm (479 kgf-cm, 35 ft-lbf)
5. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY (DRUM REAR BRAKE TYPE)
6. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
7. INSPECT ABS SPEED SENSOR SIGNAL (WITH ABS)
(a) Vehicle Stability Control System (Test Mode Procedure)

(b) Anti-lock Brake System (Test Mode Procedure)