Installation

SUSPENSION: FRONT STABILIZER BAR:

COMPONENTS






INSTALLATION

1. INSTALL STABILIZER BAR FRONT





(a) Install 2 front stabilizer bar bushes No. 1, front stabilizer bracket No. 1 LH and front stabilizer bracket No. 1 RH to the stabilizer bar front.

HINT: Install the bushing to the inner side of the bushing stopper on the stabilizer bar.





(b) Install the stabilizer bar front and 4 bolts to the front suspension crossmember sub-assembly.
Torque: 19 Nm (194 kgf-cm, 14 ft-lbf)
2. INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY (Installation)

3. INSTALL RACK & PINION POWER STEERING GEAR ASSEMBLY (Installation)

4. INSTALL FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER NO. 1 LH (Installation)

5. INSTALL FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER NO. 1 RH

HINT: Install the RH side by the same procedures as the LH side.

6. INSTALL FRONT STABILIZER LINK ASSEMBLY LH
(a) Install the stabilizer bar link with the 2 nuts.
Torque: 74 Nm (755 kgf-cm, 55 ft-lbf)

HINT: If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud.

7. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT: Install the RH side by the same procedure as the LH side.

8. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
9. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

HINT: (Service and Repair)