Installation

SUSPENSION: FRONT LOWER BALL JOINT:

COMPONENTS









INSTALLATION

1. INSTALL LOWER BALL JOINT ASSEMBLY FRONT LH
(a) Install the lower ball joint assembly front LH to the steering knuckle LH, tighten the castle nut.
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
(b) Install a new cotter pin.
2. INSTALL FRONT AXLE ASSEMBLY LH (Installation)

3. INSTALL FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER NO. 1 LH (Installation)

4. INSTALL TIE ROD END SUB-ASSEMBLY LH
5. INSTALL SPEED SENSOR FRONT LH (w/ ABS)
6. INSTALL FRONT AXLE SHAFT LH NUT (Installation)

7. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
8. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

HINT: (Service and Repair)

9. CHECK ABS SPEED SENSOR SIGNAL (w/ ABS)
(a) Anti-lock Brake System: (Test Mode Procedure)

(b) Vehicle Stability Control System: (Test Mode Procedure)