Removal

SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY:

COMPONENTS






REMOVAL

HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the RH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag from deploying.

2. REMOVE FRONT DOOR SCUFF PLATE RH (Removal)

3. REMOVE FRONT DOOR WEATHERSTRIP RH
4. REMOVE REAR DOOR SCUFF PLATE RH (Removal)

5. REMOVE REAR DOOR WEATHERSTRIP RH
6. REMOVE CENTER PILLAR GARNISH LOWER RH (Removal)

7. REMOVE FRONT SEAT OUTER BELT ASSEMBLY RH

CAUTION:
- Removal of the seat belt pretensioner must be started at least 90 seconds after the ignition switch is turned OFF and the negative (-) terminal cable is disconnected from the battery.
- Carefully read the notices for the "pretensioner" in the SRS airbag system and front seat outer belt assembly.





(a) Using a screwdriver, remove the shoulder anchor cover.

HINT: Tape the screwdriver tip before use.

(b) Remove the bolt and disconnect the front seat outer belt (shoulder anchor side).
(c) Using screwdriver, remove the floor anchor cover.
(d) Remove the bolt and disconnect the front seat outer belt assembly RH (floor anchor side).

HINT: Tape the screwdriver tip before use.





(e) To disconnect the pretensioner connector: 1) horizontally pull out the lock part of the connector as indicated by the black arrow in the illustration, and 2) remove the connector.
(f) Remove the 2 bolts and front seat outer belt assembly RH.
8. REMOVE CENTER PILLAR GARNISH RH (Removal)

9. REMOVE FRONT SHOULDER ANCHOR ADJUSTER ASSEMBLY
(a) Remove the bolt and front shoulder belt anchor adjuster assembly.