Removal

SUPPLEMENTAL RESTRAINT SYSTEM: CURTAIN SHIELD AIRBAG ASSEMBLY:

COMPONENTS






REMOVAL

HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.

1. PRECAUTION

CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing (Service Precautions).

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTE: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

3. REMOVE ROOF HEADLINING ASSEMBLY

HINT: Refer to the procedures up to "REMOVE ROOF HEADLINING ASSEMBLY" (Removal).

4. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH
(a) Disconnect the connector from the curtain shield airbag assembly LH.

NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.

(b) Remove the clip.
(c) Remove the 3 bolts, 6 screws and the curtain shield airbag assembly LH in the order shown in the illustration.