Installation

SUPPLEMENTAL RESTRAINT SYSTEM: CURTAIN SHIELD AIRBAG ASSEMBLY:

COMPONENTS






INSTALLATION

HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.

1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH
(a) Install the curtain shield airbag assembly LH with the 3 bolts and 6 screws in the order shown in the illustration.





Torque: 9.8 Nm (100 kgf-cm, 7 ft-lbf)

NOTE: Do not twist the curtain shield airbag assembly LH when installing it.

(b) Install the clip.
(c) Connect the connector to the curtain shield airbag assembly LH.

NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.

2. INSTALL ROOF HEADLINING ASSEMBLY

HINT: Refer to the procedures from "INSTALL ROOF HEADLINING ASSEMBLY" (Installation).

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4. PERFORM INITIALIZATION
(a) Perform initialization.

HINT: Some systems need initialization when disconnecting the cable from the negative battery terminal.

5. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light (Diagnosis System).