FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.

Reassembly










PARKING BRAKE: PARKING BRAKE ASSEMBLY:

COMPONENTS





REASSEMBLY

1. APPLY HIGH TEMPERATURE GREASE





(a) Apply the high temperature grease to the shoe attached surface of backing plate.
2. INSTALL PARKING BRAKE SHOE LEVER LH





(a) Using needle-nose pliers, connect the parking brake cable assembly No. 3 to the parking brake shoe lever LH.
3. INSTALL PARKING BRAKE SHOE ASSEMBLY LH NO. 2





(a) Apply the high temperature grease to the contact part of the parking brake shoe and parking brake shoe lever.





(b) Using SST, install the parking brake shoe LH No. 2 with the parking brake shoe hold-down compression spring and parking brake shoe hold-down spring pin.
SST: 09718-00010
4. INSTALL PARKING BRAKE SHOE ASSEMBLY LH NO. 1





(a) Using SST, install the parking brake shoe LH No.1 with the parking brake shoe hold-down compression spring and parking brake shoe hold-down spring pin.
SST: 09718-00010
5. INSTALL PARKING BRAKE SHOE ADJUSTING SCREW SET





(a) Apply the high temperature grease to the adjusting bolt and support piece.
(b) Install the parking brake shoe adjusting screw set LH.





(c) Using needle-nose pliers, install the tension spring.
6. INSTALL PARKING BRAKE SHOE STRUT LH





(a) Apply the high temperature grease to the contact part of the shoe strut and tension spring.
(b) Install the parking brake shoe strut LH.





(c) Using needle-nose pliers, install the 2 upper side tension springs.

HINT: Install the 2 tension spring securely to the grooves of the shoe strut.

7. CHECK PARKING BRAKE INSTALLATION
(a) Check that each part is installed properly.





NOTE: There should be no oil or grease on the friction surface of the shoe lining and disc.

8. INSTALL REAR DISC
9. ADJUST PARKING BRAKE SHOE CLEARANCE
(a) Temporarily install the hub nuts.
(b) Remove the hole plug, and turn the adjuster and expand the shoes until the disc locks.





(c) Contract the shoe adjuster until the disc can rotate smoothly.
Standard:
Return to 8 notches
(d) Check that there is no brake drag.
(e) Install the hole plug.
10. CONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH
11. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
12. INSPECT PARKING BRAKE LEVER TRAVEL (Adjustments)

13. ADJUST PARKING BRAKE LEVER TRAVEL (Adjustments)