Installation

PARKING BRAKE: PARKING BRAKE CABLE:

COMPONENTS





INSTALLATION

1. INSTALL PARKING BRAKE CABLE ASSEMBLY NO. 3
(a) Connect the parking brake cable assembly No. 3 to the equalizer.
(b) Install the parking brake cable assembly No. 3 with the 4 bolts and cable retainer.
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)









(c) Connect the skid control sensor wire harness clip to the clamp.
2. INSTALL FUEL TANK PROTECTOR NO. 1
(a) Install the fuel tank protector No. 1 with the 5 nuts.
Torque: 5.5 Nm (55 kgf-cm, 48 in-lbf)
3. INSTALL FRONT FLOOR HEAT INSULATOR NO. 2 (Installation)

4. INSTALL FRONT FLOOR HEAT INSULATOR NO. 1 (Installation)

5. INSTALL EXHAUST PIPE ASSEMBLY FRONT (Installation)

6. CONNECT PARKING BRAKE CABLE ASSEMBLY NO. 3





(a) Connect the parking brake cable assembly No. 3 to the backing plate with the bolt.
Torque: 7.8 Nm (80 kgf-cm, 69 in-lbf)
7. APPLICATION HIGH TEMPERATURE GREASE (for Drum Type) (Reassembly)

8. INSTALL REAR BRAKE SHOE (for Drum Type) (Reassembly)

9. INSTALL REAR BRAKE AUTOMATIC ADJUST LEVER LH (for Drum Type)
10. INSTALL PARKING BRAKE SHOE STRUT SET LH (for Drum Type) (Reassembly)

11. INSTALL FRONT BRAKE SHOE (for Drum Type) (Reassembly)

12. CHECK REAR DRUM BRAKE INSTALLATION (Reassembly)

13. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY (for Drum Type)
14. ADJUST REAR DRUM BRAKE SHOW CLEARANCE (for Drum Type) (Reassembly)

15. APPLICATION HIGH TEMPERATURE GREASE (for Disc Type) (Reassembly)

16. INSTALL PARKING BRAKE SHOE LEVER LH (for Disc Type) (Reassembly)

17. INSTALL PARKING BRAKE SHOE ASSEMBLY LH NO. 2 (for Disc Type) (Reassembly)

18. INSTALL PARKING BRAKE SHOE ASSEMBLY LH NO. 1 (for Disc Type) (Reassembly)

19. INSTALL PARKING BRAKE SHOE ADJUSTING SCREW SET (for Disc Type) (Reassembly)

20. INSTALL PARKING BRAKE SHOE STRUT LH (for Disc Type) (Reassembly)

21. CHECK PARKING BRAKE INSTALLATION (for Disc Type) (Reassembly)

22. INSTALL REAR DISC (for Disc Type)
23. ADJUST PARKING BRAKE SHOE CLEARANCE (for Disc Type) (Reassembly)

24. CONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH (for Disc Type) (Installation)

25. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
26. INSPECT PARKING BRAKE LEVER TRAVEL (Adjustments)

27. ADJUST PARKING BRAKE LEVER TRAVEL (Adjustments)

28. INSPECT FOR EXHAUST GAS LEAK