Installation

BRAKE CONTROL: ABS AND TRACTION ACTUATOR:

COMPONENTS

















INSTALLATION

1. INSTALL ABS AND TRACTION ACTUATOR ASSEMBLY
(a) Install the ABS and traction actuator assembly with the 2 nuts to the bracket.
Torque: 6.0 Nm (61 kgf-cm, 53 in-lbf)
2. INSTALL BRAKE ACTUATOR WITH BRACKET





(a) Install the actuator with bracket with the 2 bolts and nut.
Torque: 20 Nm (204 kgf-cm, 15 ft-lbf)

- Be careful not to damage the brake tubes and wire harness.
- Tighten the bolts in order from 1 to 3.

(b) Connect the actuator connector.

NOTE: Make sure that the lever is locked securely.





(c) Using SST, connect each brake tube to correct positions of the actuator with bracket, as shown in the illustration.
SST: 09023-00101
Torque: 15 Nm (155 kgf-cm, 11 ft-lbf)
3. INSTALL WINDSHIELD WASHER JAR ASSEMBLY
4. INSTALL LH HEADLIGHT ASSEMBLY
5. INSTALL FRONT BUMPER COVER
6. INSTALL FRONT FENDER LINER RH
7. INSTALL FRONT WHEEL RH
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
8. FILL RESERVOIR WITH BRAKE FLUID

HINT: (Service and Repair)

9. BLEED MASTER CYLINDER
SST: 09023-00101

HINT: (Service and Repair)

10. BLEED BRAKE LINE

HINT: (Service and Repair)

11. BLEED ABS AND TRACTION ACTUATOR ASSEMBLY

HINT: (Service and Repair)

12. CHECK FLUID LEVEL IN RESERVOIR

HINT: (Service and Repair)

13. INSPECT FOR BRAKE FLUID LEAK
14. CHECK ACTUATOR WITH TECHSTREAM

HINT: (Brake Actuator)

15. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION

HINT: (Programming and Relearning)

16. PREPARE VEHICLE FOR FOG LIGHT AIMING ADJUSTMENT (Adjustments)

17. PREPARE FOR FOG LIGHT AIMING (Adjustments)

18. INSPECT FOG LIGHT AIMING (Adjustments)

19. ADJUST FOG LIGHT AIMING (Adjustments)

20. PREPARE VEHICLE FOR HEADLIGHT AIMING ADJUSTMENT (Adjustments)

21. PREPARE FOR HEADLIGHT AIMING (for Using a Tester) (Adjustments)

22. PREPARE FOR HEADLIGHT AIMING (for Using a Screen) (Adjustments)

23. INSPECT HEADLIGHT AIMING (Adjustments)

24. ADJUST HEADLIGHT AIMING (Adjustments)