Front No. 1 Speaker

ON-VEHICLE INSPECTION

1. INSPECT FRONT NO. 1 SPEAKER

HINT: Remove interior parts so that the front No. 1 speaker can be seen.

a. Check the speaker installation.

OK: The speaker is securely installed.

If the result is not as specified, reinstall the front No. 1 speaker.

b. Visually check the speaker.

OK: The cone paper of the speaker is not torn.

c. Speaker resistance check.

1. Disconnect the front No. 1 speaker connector.
2. Measure the resistance between the terminals of the speaker.

Standard resistance:
Separate Type Amplifier System (Coupe): 3 to 4 ohms
Separate Type Amplifier System (Convertible): 4 to 6 ohms
Built-in Type Amplifier System: 3.2 to 4.8 ohms

If the result is not as specified, replace the front No. 1 speaker.