Rear Axle Hub

REAR AXLE HUB

COMPONENTS:

ON-VEHICLE INSPECTION
1. INSPECT REAR AXLE HUB BEARING
(a) Remove the rear wheel.
(b) Remove rear brake drum sub-assembly.





(c) Inspect the bearing backlash.
(1) Using a dial indicator, check the backlash near the center of the axle hub.
Maximum: 0.05 mm (0.0020 in.)

If the backlash exceeds the maximum, replace the rear axle hub & bearing assembly.





(d) Inspect the axle hub deviation.
(1) Using a dial indicator, check the deviation at the surface of the axle hub outside the hub bolt.
Maximum: 0.07 mm (0.0028 in.)

If the backlash exceeds the maximum, replace the rear axle hub & bearing assembly.

(e) Install the rear brake drum sub-assembly.
(f) Install the rear wheel.
Torque: 103 Nm (1,050 kgf/cm, 76 ft. lbs.)

REMOVAL
1. REMOVE REAR WHEEL





2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY LH (DISC REAR BRAKE TYPE)
(a) Remove the 2 bolts, separate the rear disc brake caliper assembly LH.

3. REMOVE REAR DISC (DISC REAR BRAKE TYPE)
4. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY (DRUM REAR BRAKE TYPE)
5. DISCONNECT SKID CONTROL SENSOR WIRE (WITH ABS)





6. REMOVE REAR AXLE HUB & BEARING ASSEMBLY LH
(a) Remove the 4 bolts and hub & bearing assembly LH.

INSTALLATION





1. INSTALL REAR AXLE HUB & BEARING ASSEMBLY LH
(a) Install the hub & bearing assembly LH with the 4 bolts.
Torque: 61 Nm (622 kgf/cm, 45 ft. lbs.)

2. CONNECT SKID CONTROL SENSOR WIRE (WITH ABS)

NOTICE: Do not twist the sensor wire when connecting it.

3. INSTALL REAR DISC (DISC REAR BRAKE TYPE)





4. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH (DISC REAR BRAKE TYPE)
(a) Install the rear disc brake caliper assembly LH with 2 bolts.
Torque: 47 Nm (479 kgf/cm, 35 ft. lbs.)

5. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY (DRUM REAR BRAKE TYPE)
6. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf/cm, 76 ft. lbs.)

7. INSPECT ABS SPEED SENSOR SIGNAL (WITH ABS)
(a) Vehicle Stability Control System
(b) Anti-lock Brake System