Seals and Gaskets: Service and Repair
DIFFERENTIAL OIL SEALCOMPONENTS (Part 1):
COMPONENTS (Part 2):
COMPONENTS (Part 3):
COMPONENTS (Part 4):
REMOVAL
1. REMOVE FRONT WHEELS
2. REMOVE ENGINE UNDER COVER RH
3. REMOVE ENGINE UNDER COVER LH
4. DRAIN AUTOMATIC TRANSAXLE FLUID
(a) Remove the drain plug, gasket and drain ATF.
(b) Install a new gasket and drain plug.
Torque: 18 Nm (180 kgf/cm, 13 ft. lbs.)
5. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH
6. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
7. REMOVE TRANSAXLE HOUSING OIL SEAL (for RH Side)
(a) Using SST, pull out the oil seal.
SST 09308-00010
8. REMOVE TRANSAXLE CASE OIL SEAL (for LH Side)
(a) Using SST, pull out the oil seal.
SST 09308-00010
INSTALLATION
1. INSTALL TRANSAXLE HOUSING OIL SEAL (for RH Side)
(a) Using SST and a hemmer, drive in a new oil seal.
SST 09350-32014 (09351-32130, 09351-32150)
Oil seal drive in depth: 1.5 to 2.5 mm (0.059 to 0.098 in.)
(b) Coat the lip of the oil seal with MP grease.
2. INSTALL TRANSAXLE CASE OIL SEAL (for LH Side)
(a) Using SST and a hammer, drive in a new oil seal.
SST 09350-32014 (09351-32111, 09351-32130)
Oil seal drive in depth: 4.8 to 5.8 mm (0.189 to 0.228 in.)
(b) Coat the lip of the oil seal with MP grease.
3. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
4. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
5. INSTALL ENGINE UNDER COVER LH
6. INSTALL ENGINE UNDER COVER RH
7. INSTALL FRONT WHEELS
Torque: 103 Nm (1,050 kgf/cm, 76 ft. lbs.)
8. ADD AUTOMATIC TRANSAXLE FLUID
Fluid type: T-IV
Capacity: 3.0 liters (3.2 US qts, 2.6 Imp.qts)
9. INSPECT AUTOMATIC TRANSAXLE FLUID
10. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
11. CHECK ABS SPEED SENSOR SIGNAL (w/ ABS)