Rear Side Speaker

Rear Side Speaker:

Rear Side Speaker

REMOVAL

1. REMOVE REAR DOOR PULL HANDLE
2. REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)
3. REMOVE REAR DOOR TRIM BOARD SUBASSEMBLY LH




4. REMOVE REAR SPEAKER

a. Disconnect the connector.
b. Using a drill of less than Dia. 4 mm (0.16 in.), drill out the 3 rivet heads and remove the rear speaker from the rear door panel.
c. Gently and vertically put the drill to the rivet, and cut the rivet flanges.

NOTE:
- Prizing the hole with a drill can lead to damage to the rivet hole or breaking the drill.
- Take care as the cut rivet is hot.

d. Even if flange is taken off, continue drilling and push out remaining fragments with the drill.
e. Using a vacuum cleaner, remove the drilled rivet and their dust from the inside of the rear door panel.

INSTALLATION




1. INSTALL REAR SPEAKER
a. Using an air riveter or hand riveter, 3 new strike rivets install the rear speaker to the rear door panel.

NOTE:
- Install the new strike rivet in following order shown in the illustration to install the rear speaker.
- Do not prize a riveter, as riveter is damaged, it is not tightened and the mandrel is bent.
- Do not tilt the riveter and disconnect the rivet from the material while handling a riveter, as the materials are not tightened firmly.
- Install the rivet while attaching materials, as they are not tightened firmly.

b. Connect the connector.

2. INSTALL REAR DOOR TRIM BOARD SUBASSEMBLY LH
3. INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)
4. INSTALL REAR DOOR PULL HANDLE