Antenna Cable: Service and Repair

Radio Antenna Cord:

Radio Antenna Cord

REMOVAL

1. REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

HINT: Refer to the instructions for removal of the upper instrument panel sub-assembly.







2. REMOVE RADIO WIRE SUB-ASSEMBLY
a. Disconnect the connector.
b. Remove the 3 clamps and radio wire sub-assembly.

3. REMOVE ROOF HEADLINING ASSEMBLY

HINT: Refer to the instructions for removal of the roof headlining assembly.

4. REMOVE ANTENNA CORD SUB-ASSEMBLY
a. Remove the antenna cord sub-assembly from the roof headlining assembly.

INSTALLATION

1. INSTALL ANTENNA CORD SUB-ASSEMBLY




a. Tape the antenna cord sub-assembly at the position of the roof headlining assembly shown in the illustration.

NOTE:
- The antenna cord sub-assembly should come to the center of the tape (100 mm (3.94 in.) x 25 mm (0.98 in.)) when taped.
- Try not to touch the adhesive side of the tape when taping.

2. INSTALL ROOF HEADLINING ASSEMBLY

HINT: Refer to the installation procedures of the roof headlining assembly.

3. INSTALL REAR SEAT CUSHION ASSEMBLY AND REAR SEATBACK ASSEMBLY
4. INSTALL RADIO WIRE SUB-ASSEMBLY
5. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY

HINT: Refer to the installation procedures of the upper instrument panel sub-assembly.