With Manufacturer's Scan Tool
Check for DTCsNOTE:
Hand-held tester only:
When the diagnostic system is switched from normal mode to check mode, all DTCs and freeze frame data recorded in normal mode will be erased. Before switching modes, always check for DTCs and freeze frame data, and write them down.
NOTE:
1. Prepare an OBD II scan tool (complying with SAE J1978) or hand-held tester.
2. Connect the OBD II scan tool or hand-held tester to the DLC3 in the lower part of the instrument panel.
3. Turn the ignition switch ON and turn the OBD II scan tool or hand-held tester switch ON.
4. Use the OBD II scan tool or hand-held tester to check for DTCs and freeze frame data and write them down. (for operating instructions, see the OBD II scan tool's instruction book).
5. See Trouble Code Descriptions to confirm the details of the DTCs.