Power Mirror Position Switch/Sensor: Testing and Inspection

W/ Driving position memory:
INSPECT MIRROR POSITION SENSORS OPERATION

HINT: Strip off the vinyl tape of the connector and remove terminals 2, 3, 6, 7 and 9 from the connector housing.

a. Connect a series of three 1.5 V dry cell batteries.
b. Connect the positive (+) lead from the dry cell batteries to terminal 7 and the negative (-) lead to terminal 6.
c. Connect the positive (+) lead from the voltmeter to terminal 9 and the negative (-) lead to terminal 6.







d. Apply Battery voltage to terminals 2 and 3, then check that the voltage gradually changes according to the table while the mirror moves between the uppermost position and lowermost position.

If voltage value is not as specified, replace the motor assembly.




e. Disconnect the 4 leads of the battery and voltmeter.
f. Connect the positive (+) lead from the voltmeter to terminal 8 and negative (-) lead to terminal 6.







g. Apply Battery voltage to terminals 2 and 1, then inspect that the voltage gradually changes according to the table while the mirror moves between the left-most position and right-most position.

If voltage value is not as specified, replace the motor assembly.