Air Inlet Servomotor
1. REMOVE THESE PARTSa. Remove front door scuff plate RH
b. Remove cowl side trim RH
c. Remove lower No. 2 finish panel
d. Remove glove compartment door
e. Remove glove compartment
2. REMOVE THE INLET SERVOMOTOR
a. Disconnect the connector
b. Remove the 3 screws and servomotor
3. Manual A/C:
INSPECT AIR INLET SERVOMOTOR
Inspect the servomotor operation.
1. Connect the positive (+) lead from the battery to terminal 7 and negative (-) lead to terminal 3.
2. Check the motor arm rotates counterclockwise and arm stops on the "FRESH" position.
3. Connect the positive (+) lead from the battery to terminal 7 and negative (-) lead to terminal 1.
4. Check the motor arm rotates counterclockwise and arm stops on the "RECIRC" position.
If operations are not as specified, replace the servomotor
4. Auto A/C:
INSPECT AIR INLET SERVOMOTOR
a. Inspect the servomotor operation.
1. Connect the positive (+) lead from the battery to terminal 6 and negative (-) lead to terminal 7, then check that the arm turns to "FRESH" side smoothly.
2. Connect the positive (+) lead from the battery to terminal 7 and negative (-) lead to terminal 6, then check that the arm turns to "RECIRC" side smoothly.
If operations are not as specified, replace the servomotor.
b. Inspect position sensor resistance.
Measure resistance between terminals at servomotor arm each position as shown in the illustration.
If resistance is not as specified , replace the servomotor.
5. INSTALL AIR INLET SERVOMOTOR
a. Install the servomotor with the 3 screws.
b. Connect the connector
6. INSTALL THESE PARTS
a. Install glove compartment
b. Install glove compartment door
c. Install lower No. 2 finish panel
d. Install cowl side trim RH
e. Install front door scuff plate RH