Vacuum Brake Booster: Service and Repair
REMOVAL1. REMOVE MASTER CYLINDER.
2. REMOVE CHARCOAL CANISTER AND BRACKET
3. DISCONNECT VACUUM HOSE FROM BRAKE BOOSTER
4. REMOVE PEDAL RETURN SPRING
5. REMOVE CLIP AND CLEVIS PIN
6. REMOVE BRAKE BOOSTER, GASKET AND CLEVIS
a. Remove the 4 nuts and clevis.
b. Pull out the brake booster and gasket.
INSTALLATION
1. INSTALL BRAKE BOOSTER
a. Install the booster and a new gasket.
b. Install the clevis to the operating rod.
c. Install and torque the booster installation nuts.
Torque: 13 Nm (130 kgf-cm, 9 ft. lbs.)
d. Install the clevis pin into the clevis and brake pedal, and install the clip to the clevis pin.
e. Install the pedal return spring.
2. ADJUST LENGTH OF BOOSTER PUSH ROD
a. Install the gasket on the master cylinder.
b. Set the Special Service Tools (SST) on the gasket, and lower the pin until its tip slightly touches the piston.
SST 09737-00010
c. Turn the SST upside down, and set it on the booster.
SST 09737-00010
d. Measure the clearance between the booster push rod and pin head (SST).
Clearance: 0 mm (0 inch)
e. Adjust the booster push rod length until the push rod slightly touches the pin head.
3. INSTALL CHARCOAL CANISTER AND BRACKET
4. INSTALL MASTER CYLINDER.
5. CONNECT VACUUM HOSE TO BRAKE BOOSTER
6. FILL BRAKE RESERVOIR WITH BRAKE FLUID AND BLEED BRAKE SYSTEM.
7. CHECK FOR LEAKS
8. CHECK AND ADJUST BRAKE PEDAL.
9. DO OPERATIONAL CHECK.