Rear

REMOVAL
1. Remove rear wheels.
Torque: 103 Nm (76 ft. lbs.)





2. Remove left and right stabilizer bar links. Remove the 4 nuts and 2 links.

HINT: If the ball joint turns together with the nut, use a 5 mm hexagon wrench to hold the stud.

Torque: 39 Nm (23 ft. lbs.)
3. Remove heat insulator.
Remove the 3 bolts, clip and heat insulator.





4. Remove left and right brackets and bushings.
Removing the 4 bolts, 2 brackets and bushings.
Torque: 19 Nm (14 ft. lbs.)

HINT: At the time of installation, install the bushing to the outside of the bushing on the stabilizer bar.

5. Remove stabilizer bar.

INSTALLATION
Installation is in the reverse order of removal.