Radius Arm: Service and Repair

REMOVAL
1. Remove rear wheel.
Torque: 103 Nm (76 ft. lbs.)
2. Remove exhaust center pipe.




3. Remove strut rod.
a. Remove the bolt and disconnect the parking brake cable.
Torque: 5.4 Nm (48 inch lbs.)
b. Remove the 2 bolts and nuts.
Torque: 113 Nm (83 ft. lbs.)

HINT: At time of installation, after stabilizing the suspension, torque the bolts.

c. Remove the strut rod.

INSTALLATION
1. Installation is the reverse order of removal.

INSTALLATION NOTE: Face the paint mark to the rearward.