Disassembly and Assembly

DISASSEMBLY





1. Disassemble No.2 lower suspension arm.
a. Loosen the 2 lock nuts.
b. Turn and disassemble the No.2 lower suspension arm.
c. Remove the lock nuts from the No.2 lower suspension arm.

REASSEMBLY
1. Assemble No.2 lower suspension arm.





a. Install the 2 lock nuts to the No.2 lower suspension arm.
b. Turn the adjusting tube and assemble the No.2 lower suspension arm.





HINT: When assembling the No.2 lower suspension arm, try to make dimensions A and B shown in the illustration as close as possible.

Maximum difference: 3.0 mm (0.118 inch)





c. Adjust the No.2 lower suspension arm length by turning the adjusting tube.
Arm length: 512.3 mm (20.169 inch).
d. Temporarily tighten the 2 lock nuts.

HINT: After adjusting the rear wheel alignment, torque the lock nuts.

Torque: 56 Nm (41 ft. lbs.)