With Toyota Hand-Held Tester

SPEED SENSOR SIGNAL INSPECTION

Using TOYOTA hand-held tester, check the speed sensor signal.





(1) Using 55T, connect terminals Ts and E1 of DLC1. SST 09843-18020
(2) Start the engine.





(3) Check that the ABS warning light blinks.

HINT: If the ABS warning light does not blink, inspect the ABS warning light circuit.

(4) Drive vehicle straight forward.

HINT:
- Drive vehicle at 45 - 55 km/h (28 - 34 mph) for several seconds.
- If the brake is applied during the check, the check routine must be started again.

(5) Stop the vehicle.





(6) Hook up the TOYOTA hand-held tester to the DLC2.
(7) Read the DTC by following the prompts on the tester screen.

HINT: Please refer to the TOYOTA hand-held tester operator's manual for further details.





Check the DTC of the speed sensor function.