Removal and Installation

REMOVAL
1. Remove right front fender liner.
2. Remove A/C tube clamp bracket bolt.
3. Remove power steering hose clamp bolt.





4. Disconnect brake lines.
Using Special Service Tool (SST) 09751-36011 or equivalent, disconnect the 6 brake lines from the ABS actuator.
Torque: 15 Nm (11 ft. lbs.)





5. Disconnect connector.
Pull out the release bar, and disconnect the connector.
6. Remove ABS actuator assembly.
Remove the 2 bolts, 2 nuts and ABS actuator assembly.
Torque: 19 Nm (14 ft. lbs.)
7. Remove ABS actuator.
a. Remove the 2 nuts and ABS actuator.
Torque: 9.0 Nm (80 inch lbs.)
b. Remove the 2 holders and 3 cushions from the ABS actuator.

INSTALLATION
Installation is in the reverse order of removal.
After installation, fill brake reservoir with brake fluid, bleed brake system and check for leaks.