Installation

1. Install bearing.
a. Using Special Service Tool (SST) 09608 - 32010 and a press, install a new bearing to the steering knuckle.
b. Using snap ring pliers, install a new snap ring.
2. Install dust cover; using a torx wrench (T30), torque the 4 bolts to 8.3 Nm (74 inch lbs.).





3. Install front axle hub, using SST 09310 - 35010, 09608 - 32010 and a press.
4. Install lower ball joint.
a. Install the lower ball joint and torque the nut to 123 Nm (90 ft. lbs.).
b. Install a new cotter pin.





5. Install dust deflector; using SST 09316 - 60011 (09316 - 00011, 09316 - 00041), 09608-32010 and a hammer.

NOTE: Align the holes for the ABS speed sensor in the dust deflector and steering knuckle.

6. Install Steering Knuckle, refer to Steering and Suspension.