Rear

1. Remove rear wheels.
[Torque: 103 Nm (76 ft. lbs.)]





2. Remove left and right stabilizer bar links. Remove the 4 nuts and 2 links.
[Torque: 39 Nm (23 ft. lbs.)]

NOTE: If the ball joint turns together with the nut, use a 5 mm hexagon wrench to hold the stud.

3. Remove heat insulator. Remove the 3 bolts, clip and heat insulator.





4. Remove left and right brackets and bushings by removing the 4 bolts.
[Torque: 19 Nm (14 ft. lbs.)]

Installation Note: Install the bushing to the outside of the bushing on the stabilizer bar.

5. Remove stabilizer bar.