Steering Column: Specifications

SERVICE SPECIFICATIONS
Pawl Stopper
Mark:
1 or A 12.68-12.74 mm (0.4992-0.5016 inch)
2 or B 12.61-12.67 mm (0.4965-0.4988 inch)
3 or C 12.54-12.60 mm (0.4937-0.4961 inch)
4 or D 12.47-12.53 mm (0.4909-0.4933 inch)
5 or E 12.40-12.46 mm (0.4882-0.4906 inch)
6 or F 12.33-12.39 mm (0.4854-0.4878 inch)
7 or G 12.26-12.32 mm (0.4827-0.4850 inch)

TIGHTENING SPECIFICATIONS
Column Assembly Set Nut 25 Nm (19 ft. lbs.)
Compression Spring Set Screw 6.4 Nm (56 inch lbs.)
Intermediate Shaft To Sliding Yoke 35 Nm (26 ft. lbs.)
Sliding Yoke To Control Valve Shaft 35 Nm (26 ft. lbs.)
Steering Wheel:
Pad Set Screw 7.1 Nm (62 inch lbs.)
Set Nut 35 Nm (26 ft. lbs.)
Tilt Lever Assembly Set Screw 4.7 Nm (42 inch lbs.)
Tilt Lever Retainer Set Nut 15 Nm (11 ft. lbs.)
Tilt Memory Bolt Set Nut 5.9 Nm (52 inch lbs.)
Tilt Memory Bolt To Square Nut 6.4 Nm (56 inch lbs.)
Tilt Pawl Set Nut 5.9 Nm (52 inch lbs.)
Turn Signal Bracket Set Bolt 8.8 Nm (78 inch lbs.)