When Scrapping Vehicle
DEPLOYMENT/DISPOSAL WHEN SCRAPPING VEHICLEHINT: Have a battery ready as the power source to deploy the airbag.
1. Confirm functioning of SST 09082-00700.
(a) When deploying the airbag. always use the specified SST: SRS AIRBAG DEPLOYMENT TOOL SST 09082-00700.
(b) Connect the red clip of the SST to the battery positive (+) terminal and the black clip to the battery negative (-) terminal.
HINT: Do not connect the yellow connector which connects with the airbag system.
(c) Press the SST activation switch. and confirm the LED of the SST activation switch lights up.
CAUTION: If the LED lights up when the activation switch is not being pressed, SST malfunction is probable, so definitely do not use the SST.
2. Disconnect airbag connectors.
Driver side:
(a) Remove the No.1 under cover.
(b) Disconnect the airbag connector of the spiral cable.
Passenger side:
(a) Remove the glove compartment door finish plate inside the glove compartment.
(b) Pull up the connector.
(c) Disconnect the airbag connector.
3. Install the SST 09082-00700.
(a) Connect the SST connector to the airbag connector.
NOTICE: To avoid damaging the SST connector and wire harness, do not lock the secondary lock of the twin lock.
(b) Move the SST to at least 10 m (33 ft) from the front of the vehicle.
(c) Close all the doors and windows of the vehicle.
NOTICE: Take care not to damage the SST wire harness.
(d) Connect the SST red clip to the battery positive (+) terminal and the black clip to the battery negative (-) terminal.
4. Deploy the airbag.
(a) Confirm that no-one is inside the vehicle or within 10 m (33 ft) of the vehicle.
(b) Press the SST activation switch and deploy the airbag. HINT: The airbag deploys simultaneously as the LED of the SST activation switch lights up.
5. Disposal of steering wheel pad/front passenger airbag assembly.
CAUTION:
- The steering wheel pad/front passenger airbag assembly is very hot when the airbag is deployed, so leave It alone for at least 30 minutes after deployment.
- Use gloves and safety glasses when handling a steering wheel pad/front passenger airbag assembly with a deployed airbag.
- Do not apply water, etc. to a steering wheel pad/ front passenger airbag assembly with a deployed airbag.
- Always wash your hands with water after completing the operation.
When scrapping a vehicle, deploy the airbag and scrap the vehicle with the steering wheel pad/front passenger airbag assembly still installed.