Transmission Position Sensor/Switch: Service and Repair

PARK/NEUTRAL POSITION SWITCH REPLACEMENT
1. REMOVE AIR CLEANER ASSEMBLY



2. DISCONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR
3. REMOVE PARK/NEUTRAL POSITION SWITCH



- Remove the nut and disconnect the control cable.



- Remove the nut, washer and transaxle control shaft lever.
- Pry off the lock plate and remove the nut.
- Remove the 2 bolts and park/neutral position switch.
4. INSTALL AND ADJUST PARK/NEUTRAL POSITION SWITCH



- Install the park/neutral position switch with the 2 bolts.
- Install a new lock plate and nut.
- Stake the nut with the lock plate.



- Adjust the park/neutral position switch.



- Install the transaxle control shaft lever, washer and nut.



- Install the control cable with the nut.

Torque: 15 Nm (150 kgf.cm, 11 ft.lb)




5. CONNECT PARK / NEUTRAL POSITION SWITCH CONNECTOR
6. TEST DRIVE VEHICLE