Ignition Coil: Service and Repair

IGNITION COILS REMOVAL
1. DISCONNECT HIGH-TENSION CORDS FROM IGNITION COILS



- Using a screwdriver, lift up the lock claw and disconnect the holder from the ignition coils.
- Disconnect the high-tension cord at the grommet.
- Do not pull on the cord.

NOTICE:
- Pulling on or bending the cords may damage the conductor inside.
- Do not wipe any of the oil from the grommet after the high-tension cord is disconnected.

2. REMOVE IGNITION COILS
- Disconnect the 3 connectors.



- Remove the 3 bolts and 3 ignition coils from the LH cylinder head.

IGNITION COILS INSTALLATION
1. INSTALL IGNITION COILS
- Install the 3 ignition coils with the 3 bolts.

Torque: 8 Nm (80 kgf.cm, 69 in.lb)

- Connect the 3 connectors.

2. CONNECT HIGH-TENSION CORDS TO IGNITION COILS



- Assemble the holder and grommet.
- Align the spline of the ignition coil with the spline of the holder, and push in the cord.




NOTICE: Check that the holder is correctly installed to the grommet and ignition coil as shown in the illustration.

- Check that the lock claw of the holder is engaged by lightly pulling the holder.