Removal and Installation

Fig. 1 Exploded View Of Rear Disc Brake Caliper Assembly.:

Fig. 2 Exloded View Of Rear Disc Brake Caliper Assembly:

1. Raise and support rear of vehicle, then remove tire and wheel assembly.
2. Disconnect brake hose from brake tube and caliper using a suitable tool.
3. Remove caliper attaching bolts, then the caliper, Figs. 1 and 2.
4. Remove anti-squeal shim(s), brake pad, anti-rattle spring, pad guide plate and pad support plate.
5. Reverse procedure to install, then bleed brake system.