Throttle Position Sensor Adjustment

THROTTLE POSITION SENSOR ADJUSTMENT



(a) Loosen the 2 set screws of the sensor.



(b) Insert a 0.65 mm (0.026 in.) feeler gauge between the throttle stop screw and stop lever.
(c) Connect the tester probe of an ohmmeter to the terminals IDL and E2 of the sensor.



(d) Gradually turn the sensor clockwise until the ohmmeter deflects, and secure it with the 2 set screws.



(e) Recheck the continuity between terminals IDL and E2.

Clearance between
lever and stop screw - (IDL - E2)
0.54 mm (0.021 in.) - Continuity
0.70 mm (0.028 in.) - No continuity

(f) Reconnect the vacuum hose to the throttle body.