Sub-Throttle Position Sensor Adjustment

SUB-THROTTLE POSITION SENSOR ADJUSTMENT



(a) Loosen the 2 set screws of the sensor.



(b) Set the sub-throttle valve to fully closed position.
(c) Insert a 0.45 mm (0.018 in.) feeler gauge, between the throttle stop screw and throttle valve gear.



(d) Connect the tester probe of an ohmmeter to the terminals IDL and E2 of the sensor.



(e) Gradually turn the sensor clockwise until the ohmmeter deflects, and secure it with the 2 set screws.



(f) Recheck the continuity between terminals IDL and E2.

Clearance between
lever and stop screw - (IDL - E2)
0.41 mm (0.018 in.) - Continuity
0.48 mm (0.019 in.) - No continuity