Camshaft Position Sensor: Service and Repair

CAMSHAFT POSITION SENSOR REMOVAL
1. DISCONNECT NEGATIVE TERMINAL CABLE FROM BATTERY.

CAUTION: Work must not be started for at least 90 seconds from the time the ignition switch is turned to the LOCK position and the negative (-) terminal cable is disconnected from the battery.

2. DISCONNECT IDLE AIR CONTROL (IAC) VALVE CONNECTOR.



3. DISCONNECT AIR HOSE FROM IAC VALVE.
4. REMOVE ENGINE HANGER.



- Remove the 2 bolts and engine hanger.



5. DISCONNECT CAMSHAFT POSITION SENSOR CONNECTORS.
6. REMOVE CAMSHAFT POSITION SENSORS.



- Remove the 4 bolts and 2 camshaft position sensors.


CAMSHAFT POSITION SENSOR INSTALLATION
1. INSTALL CRANKSHAFT POSITION SENSOR.

Torque: 6.4 Nm (56 in.lb)

2. CONNECT CAMSHAFT POSITION SENSOR CONNECTORS.
3. INSTALL ENGINE HANGER.
4. CONNECT AIR HOSE TO IAC VALVE.
5. CONNECT IAC VALVE CONNECTOR.
6. INSTALL ENGINE UNDER COVER.
7. CONNECT NEGATIVE TERMINAL CABLE TO BATTERY.