Without Scan Tool

HOW TO CLEAR DIAGNOSTIC TROUBLE CODES WITHOUT SCAN TOOL




1. After repair of the trouble area, the diagnostic code retained in memory by the ECU must be cancelled out by removing the fuse STOP (15A), located behind driver's kick panel, for 10 seconds or more, depending on ambient temperature (the lower the temperature, the longer the fuse must be left out) with the ignition switch off.

NOTE:
^ Cancellation can also be down by removing the battery negative (-) terminal, but in this case other memory systems (radio, clock etc.) will also be cancelled out.
^ If the diagnostic code is not cancelled out, it will be retained by the ECU and appear along with a new code in event of future trouble.
^ If it is necessary to work on engine components requiring removal of the battery terminal, a check must first be made to see if a diagnostic code has been recorded.

2. After cancellation, perform a road test to confirm that a "normal" code is now read on the "CHECK ENGINE" warning light.

If the same diagnostic code appears, it indicated that the trouble area has not been repaired thoroughly.