120000 MI or 192000 KM

Check
    Brakes and Traction Control
      Check fluid level. Inspect pedal freeplay. Inspect lines, hoses, master cylinder, and calipers for wear, leaks and damage. Check discs (front and rear) and drums for wear and leaks. Check parking brake.
Tighten/Torque
    Body and Frame
      Check all chassis/body nuts and bolts, torque as necessary.
Adjust
    Valve Clearance
      Check clearances and adjust if necessary.
    Idle Speed
      Adjust idle speed and fast idle speed.
Inspect
    Suspension
      Inspect bolts and nuts on chassis and body for looseness or damage.
    Steering
      Check linkages for wear and damage. Inspect boots for damage.
    Fuel Supply Line
      Inspect fuel lines, hoses and connections. Check for leaks and damage.
    Fluid - Transfer Case
      Check fluid level and condition. Check for leaks.
    Fluid - M/T
      Check fluid level and condition. Check for leaks.
    Exhaust System
      Check for cracks, corrosion and leakage. Check heat shields for debris.
    Evaporative Emission Control Canister
      Check canister and system for proper operation.
    Drive Belt
      Inspect and correct or replace if necessary. Check for cracks, wear and fluid contamination. Adjust tension if necessary.
    Constant Velocity Joint Boot
      Check boots for leaks and damage.
Replace
    Spark Plug
      Platinum plugs every 60,000 miles or non platinum plugs every 30,000 miles. Replace with correct type and gap according to manufacturers specification.
    Oil Filter, Engine
      Replace every 12 months or 10,000 miles.
    Fuel Filler Cap
      Replace filler cap gasket. Check filler neck for damage.
    Fluid - Differential
      Limited-Slip differentials only. Replace fluid and check for leaks.
    Engine Oil
      Replace every 12 months or 10,000 miles.
    Air Filter Element
      Extremely dusty conditions may require more frequent service of this component.
Clean/Repack
    Wheel Bearing
      Front bearings on rear-wheel-drive models, rear bearings on Tercel model. Clean and repack wheel bearings. Torque to 19-23 ft.lbs. then back off and retighten finger-tight.
Rotate
    Tires
Flush
    Coolant
      Flush system, replace coolant. Check specific gravity for freezing point.