Audio - Din Connector Adapter Required
89toyota03REFERENCE AUDIO
NUMBER 004 (REVISED)
DATE 04-14-89
MODEL 89 AE, EL, SV/VV
ST, YR, RN/VN, FJ
TITLE AUTO REVERSE CASSETTE (P/N 08690-00810) MODEL 5906 INSTALLATION
SERVICE TIP
During the initial installation of a model 5906 (P2) Auto-reverse cassette deck (P/N 08690-00810) the 13 pin DIN connector may not lock properly into the following radios models:
- Factory AM/FM ETR model number's 1432 & A1432 (ER).
- PIO AM/FM ETR model number's 1433 & A1433 (R2).
MODEL APPLICATION INFORMATION:
Factory AM/FM ETR PIO AM/FM ETR
Model # 1432, A1432 Model # 1433, A1433
Celica Tercel
Corolla (CPE) Corolla
Tercel Camry
Van Van
Truck/4-Runner Truck/4-Runner
INSTALLATION PROCEDURE CHANGE:
An adapter cable (P/N 00233-00802) is now required to ensure proper locking of the DIN connector.
NOTE: Corolla Sedan does not require this adapter cable due to the proximity of the Radio head unit to deck.
Once connections have been made, use a plastic tie strap or electrical tape to fasten the 13 pin DIN connector adapter cable to the vehicle wire harness (see figure on page 2).
ADDITIONAL NOTE: This change in procedure only affects the 08690-00810 deck.
FIELD FIX PROCEDURE
Due to the possibility of improper locking of the DIN connector, there is the chance for a loose connection on units installed prior to this notice. If this occurs, the radio and cassette deck units will become inoperative.
If you encounter this problem, use the following steps:
1) Verify that the applicable radio and cassette deck units are installed. (ie. model 1432, A1432, 1433, or A1433 AM/FM ETR with model 5906 Cassette Deck)
2) Install adapter cable P/N 00233-00802 as shown on the figure below.
NOTE: For instructions on warranty time, refer to Warranty bulletin # 89-12.