Receiver Dryer: Service and Repair

REMOVAL

1. Discharge refrigeration system.
2. Remove battery, reserve tank and ignitor bracket.
3. Disconnect two liquid tubes from receiver.

NOTE: Cap the open fittings immediately to keep moisture out of the system.

4. Remove receiver from receiver holder.

INSTALLATION

1. Install receiver in receiver holder.

NOTE: Do not remove the blind plugs until ready for connection.

2. Connect two liquid tubes to receiver.
Torque: 5.4 Nm (48 in. lb)
3. Reinstall ignitor bracket, reserve tank and battery.
4. If receiver was replaced, add compressor oil to compressor.
Add 20 cc (0.7 fl.oz.)
Compressor oil: DENSOOIL 6, SUNISO NO. 5GS or equivalent
5. Evacuate air from air conditioning system.
6. Charge and conditioning system with refrigerant and check for gas leakage.
Specified amount: 600 - 750 g (1.3 - 1.7 lb)