Without Scan Tool

a. Check the warning light.

When the ignition switch is turned ON, check that the ABS warning light and BRAKE warning light goes on for 3 seconds.

HINT:
- When the parking brake is applied or the level of the brake fluid is low, the BRAKE warning light is lit.
- If the indicator check result is not normal, proceed to troubleshooting for the ABS warning light circuit or brake warning light circuit.




b. In case of not using hand-held tester:
Check the DTC.

1. Using SST, connect terminals Tc and CG of DLC3.

SST 09843-18040

2. Turn the ignition switch ON.
3. Read the DTC from the ABS warning light on the combination meter.






HINT:
- If no code appears, inspect the diagnostic circuit or ABS warning light circuit.
- As on example, the blinking patterns for normal code and codes 11 and 21 are shown.

4. Codes are explained in the code table.
If 2 or more malfunctions are indicated at the same time the lowest numbered DTC will be displayed 1st.

5. After completing the check, remove the SST from the DLC3.
SST 09843-18040