With Manufacturer Scan Tool

a. Check the warning light.

When the ignition switch is turned ON, check that the ABS warning light and BRAKE warning light goes on for 3 seconds.

HINT:
- When the parking brake is applied or the level of the brake fluid is low, the BRAKE warning light is lit.
- If the indicator check result is not normal, proceed to troubleshooting for the ABS warning light circuit or brake warning light circuit.

b. In case of using hand-held tester:
Check the DTC.

1. Read the DTC by following the prompts on the tester screen.

HINT: Please refer to the hand-held tester operator's manual for further details.