Brake Assist Operate Check
BRAKE ASSIST OPERATE CHECKHINT: If the ignition switch is turned from ON to ACC or LOCK during test mode, DTC will be erased.
a. In case of not using hand-held tester:
Check the brake assist operate.
1. Using SST, connect terminals Ts and CG of DLC3.
SST 09843-18040
2. Start the engine.
3. Check that the ABS warning light blinks.
HINT: If the ABS warning light does not blink, inspect the ABS warning light circuit and Ts circuit.
4. While the vehicle is stationary, release the brake pedal for 1 seconds. Then depress the brake pedal with a force of at least 98 N (10 kgf) for more than 1 seconds.
5. While the vehicle is stationary, quickly depress the brake pedal. At this time, confirm that the ABS warning light remains lit for approximately 3 seconds.
b. In case of using hand-held tester:
Check the brake assist operate.
Do step (2) to (5) of step (a).
HINT: Please refer to the hand-held tester operator's manual for further details.