Front Door: Adjustments

ADJUSTMENT

HINT: In the RH side, work in the same procedure as in the LH side.






HINT: Since the centering bolt is used as a door hinge body side set bolt and door hinge door side set bolt, the door can not be adjusted with it on. Substitute a bolt with washer for the centering bolt.

1. ADJUST FRONT DOOR PANEL SUB-ASSEMBLY LH




a. Check that the value is within the standard value.

2. ADJUST FRONT DOOR PANEL SUB-ASSEMBLY LH




a. Using SST, adjust the door by loosening the body side hinge bolts.
SST 09812-00010

Torque: 23 N.m (235 kgf.cm, 17 ft.lbf)

b. Adjust the door by loosening the door side hinge bolts.

Torque: 27 N.m (275 kgf.cm, 20 ft.lbf)




c. Adjust the striker position by slightly loosening the striker mounting screws, and hitting the striker with a plastic hammer.

d. Tighten the striker mounting screws again.

Torque: 23 N.m (235 kgf.cm, 17 ft.lbf)