Transfer RH Bearing Retainer Oil Seal
REPLACEMENT1. DRAIN AUTOMATIC TRANSAXLE FLUID
a. Remove the drain plug, gasket and drain ATF.
b. Install a new gasket and drain plug.
2. REMOVE TRANSFER CASE NO. 1 PLUG [36114B / 98-58]
3. REMOVE TRANSFER DRAIN PLUG [36114F / 98-58]
4. REMOVE FRONT WHEEL
5. REMOVE FRONT DRIVE SHAFT ASSY RH [43410 / 98-68]
6. REMOVE TRANSFER RH BEARING RETAINER OIL SEAL [36102E / 98-58]
a. Using SST, remove the right bearing retainer oil seal.
SST 09308-00010
NOTICE: Do not damage the oil-seal-fitted surface of the case.
7. INSTALL TRANSFER RH BEARING RETAINER OIL SEAL [36102E / 98-58]
a. Using SST drive a new oil seal into the case to the position shown in the illustration.
SST 09223-46011
NOTICE: Do not install the oil seal obliquely.
b. Apply small amount of MP grease to the oil seal lip.
8. INSTALL FRONT DRIVE SHAFT ASSY RH [43410 / 98-68]
9. INSTALL FRONT WHEEL
10. ADD AUTOMATIC TRANSAXLE FLUID (A/T TRANSAXLE)
11. INSPECT AUTOMATIC TRANSAXLE FLUID (A/T TRANSAXLE)
12. INSTALL TRANSFER DRAIN PLUG [36114F / 98-58]
a. Install the drain plug with a new gasket.
13. INSTALL TRANSFER CASE NO. 1 PLUG [36114B / 98-58]
a. Supply oil up to the level 0 - 5 mm (0 - 0.1968 inch) down from the lowest end of the plug hole
Oil quantity: 0.9 L (0.95 US qts., 0.71 Imp. qts.)
NOTICE: When supplying oil, be careful to do it slowly.
b. Install the plug No. 1 with a new gasket.
Torque: 49 Nm (500 kgf-cm, 36 ft. lbs.)
14. CHECK ABS SPEED SENSOR SIGNAL
a. Check the speed sensor signal.