Transfer Extension Housing Type T Oil Seal
REPLACEMENT1. REMOVE TRANSFER CASE NO. 1 PLUG [36114B / 98-58]
2. REMOVE TRANSFER DRAIN PLUG [36114F / 98-58]
3. REMOVE EXHAUST PIPE (1MZ-FE ENGINE TYPE)
4. REMOVE EXHAUST PIPE (2AZ-FE ENGINE TYPE)
5. REMOVE PROPELLER W/CENTER BEARING SHAFT ASSY [37100 / 98-60]
6. REMOVE TRANSFER EXTENSION HOUSING TYPE T OIL SEAL [36115C / 98-58]
a. Using SST, remove the oil seal from the extension housing.
SST 09308-00010
NOTICE: Be careful not to damage the oil-seal-fitted surface and the inside surface of the bush.
7. INSTALL TRANSFER EXTENSION HOUSING TYPE T OIL SEAL [36115C / 98-58]
a. Using SST, drive a new oil seal into the extension housing to the position shown in the illustration.
SST 09550-60010 (09951-00380, 09951-00580, 09952-06010), 09950-70010 (09951-07150)
NOTICE: Do not install the oil seal obliquely.
b. Apply small amount of MP grease to the oil seal lip.
8. TEMPORARY TIGHTEN PROPELLER W/CENTER BEARING SHAFT ASSY [37100 / 98-60]
9. FULLY TIGHTEN PROPELLER W/CENTER BEARING SHAFT ASSY [37100 / 98-60]
10. INSTALL EXHAUST PIPE (1MZ-FE ENGINE TYPE)
11. INSTALL EXHAUST PIPE (2AZ-FE ENGINE TYPE)
12. INSTALL TRANSFER DRAIN PLUG [36114F / 98-58]
a. Install the drain plug with a new gasket.
13. INSTALL TRANSFER CASE NO. 1 PLUG [36114B / 98-58]
a. Supply oil up to the level 0 - 5 mm (0 - 0.1968 inch) down from the lowest end of the plug hole.
Oil quantity: 0.9 L (0.95 US qts., 0.71 Imp. qts.)
NOTICE: When supplying oil, be careful to do it slowly.
b. Install the No. 1 plug with a new gasket.
Torque: 49 Nm (500 kgf-cm, 36 ft. lbs.)